HS2 CNC Parallel Router

HS2 CNC Parallel Router

£93.10 ex VAT

Added to Favorites

SKU: CHS2PR2245 Category:

Description

HS2 CNC Parallel Router

22D x 45L x 8 Segs x 1/2” BSP Fitting

Our HS2 CNC Parallel Router has been developed for high production and can be run at 400mm/min feed rate on 30mm and 600mm/min feed rate on 20mm thick granite/quartz (subject to machine conditions and sufficient water feed). The HS2 Router has 8 x 45mm long diamond segments to enable the user to get the maximum life out of the tool when fabricating 20mm thick stone which is most commonly used on high volume projects. We recommend the bottom part be used first, then once worn set new tool height and run using top half of the tool.

Available in 22mm diameter x 45L Segment x 1/2” BSP fitting and central water feed.

Technical Info

HS2 CNC Parallel Router – 22D x 45L x 8 Segs x 1/2” BSP Fitting

General working parameters:

RPM=5500-7500

Feed 200-500mm/min (do not cut slower than 150 mm/min)

  • Check cone conditions: must be clean without rust. Pull stud should not be too worn
  • Use a reasonable number of suction cups and double check they are all the very same height in order to avoid vibrations
  • Internal water is very important: keep water filter clean.
Granite working parameters:

RPM = 5500-6000

20mm Material

Feed = 350-500 mm/min.
Start at 150/200mm/min then increase according to noise and amp indicator

*** Very important *** : when using in 2 sections: start from bottom but be sure that router cuts through the stone completely.

30mm Material

Feed = 200-400 mm/min.
Start at 150/200mm/min then increase according to noise and amp indicator.

Engineered stone working parameters:

RPM = 6000-7500

20mm Material

Feed = 350-600 mm/min.
Start at 150/200mm/min then increase according to noise and amp indicator

*** Very important *** : when using in 2 sections: start from bottom but be sure that router cuts through the stone completely.

30mm Material

Feed = 200-400 mm/min.
Start at 150/200mm/min then increase according to noise and amp indicator.

Videos

HS2 CNC Router on 20mm Quartz running at 6000rpm and 600mm/min feed rate

 

HS2 Router forming 900x500mm cut-out in 20mm Silestone Blanco Zeus quartz at 7000rpm and 600mm/min feed rate on NC250 Breton CNC